Filter
Top Products
Information Menu 22
Information Menu
Introduction
You can view configuration information for the GbE2 Interconnect Switch in the user, operator, and administrator
command modes. This chapter discusses how to use the CLI to display GbE2 Interconnect Switch information.
Menu overview
Command: /info
[Information Menu]
sys - System Information Menu
l2 - Layer 2 Information Menu
l3 - Layer 3 Information Menu
rmon - Show RMON information
link - Show link status
port - Show port information
geaport - Show system port and gea port mapping
ufd - Show Uplink Failure Detection information
dump - Dump all information
The following table describes the Information Menu options.
Table 6 Information Menu options
Command Usage
sys Displays system information.
l2 Displays the Layer 2 Information Menu.
l3 Displays the Layer 3 Information Menu.
rmon Displays the Remote Monitoring Information Menu.
link Displays configuration information about each port, including:
• Port number
• Port speed (10 Mb/s, 100 Mb/s, 1000 Mb/s, or any)
• Duplex mode (half, full, or any)
• Flow control for transmit and receive (no, yes, or any)
• Link status (up or down)
port Displays port status information, including:
• Port number
• Whether the port uses VLAN tagging or not
• Port VLAN ID (PVID)
• Port name
• VLAN membership
geaport Displays GEA port mapping information, used by service personnel.
ufd Displays Uplink Failure Detection information
dump Dumps all GbE2 Interconnect Switch information available from the Information Menu (10K or more,
depending on your configuration).
If you want to capture dump data to a file, set your communication software on your workstation to capture
session data prior to issuing the dump commands.