HP (Hewlett-Packard) 400 Network Router User Manual


 
SR Rif_table out of space
Meaning: The routing information field (RIF) table, which contains the RIFs used
to route source-routed packets between the router and the remote token
ring nodes, is out of space. It contains RIFs used for both end-station
source routing for IP as well as intermediate-station source routing for
bridging.
SR sr_es_find: Madr_table out of space
Meaning: The madr_table, the station address table (also called the MAC address
table), is out of space. It contains the station addresses of nodes that
communicate through token ring interfaces on this router. These
addresses are used for both end-station source routing for
IP as well as
intermediate-station source routing for bridging.
Action: For an HP series 200 or 400 routers: Increase available memory space by
deleting any unneeded portions of the configuration, such as
configurations for unused ports or protocols.
For an HP router 650: Increase memory on the routing engine from 8 to
16 Mbytes (using the HP J2443A memory upgrade). If this message
occurs after a memory upgrade, increase available memory space by
deleting any unneeded portions of the configuration, such as
configurations for unneeded ports or protocols.
SR Sr_es_table out of space
Meaning: The sr_es_table, the source-routing end-station table, is out of space. It
contains indexes into the station address table (madr_table) for
destination nodes that communicate through token ring interfaces
directly attached to this router. It also contains pointers to the
RIF table,
which provides the routing information for the destination nodes.
Action: The maximum number of sr_es_table entries supported by the 2-Mbyte
processor card is 1K. Upgrade the processor card to 5-Mbytes of
memory to allow 4K entries.
Event Log
Messages
17
Event Log Messages
cct: Circuit Event Messages
17-51