Filter
Top Products
octets_tx_per_sec contains the number of octets that this circuit has
transmitted in the last second.
oflo_rx contains the total number of overflows on circuit cct. An
overflow occurs when the receiver FIFO buffer is full when the link
level controller was ready to input data.
peak_frames_rx contains the peak number of frames that this circuit
has received in any given second since the last reboot.
peak_frames_tx contains the peak number of frames that this circuit
has transmitted in any given second since the last reboot.
peak_octets_rx contains the peak number of octets that this circuit
has received in any given second since the last reboot.
peak_octets_tx contains the peak number of octets that this circuit
has transmitted in any given second since the last reboot.
rcv_desc_cnt contains the current number of receiver data buffers
available to the link level controller.
rejects_rx contains the count of supervisory REJ (Reject) frames
received by circuit cct. A REJ frame is a negative acknowledgment and
requests the retransmission of specified I (Information) frames.
rejects_tx contains the number of supervisory REJ (Reject) frames
transmitted by circuit cct. A REJ frame is a negative acknowledgment
and requests the retransmission of specified I (Information) frames.
runts_rx contains the aggregate number of frames of insufficient
length received by circuit cct.
rx_peak_rate contains the peak data receive rate in bits per second.
rx_rate contains the current data receive rate in bits per second.
t1_tos contains the number of T1 timeouts. The T1 timer measures
the interval between command transmission and the receipt of a
response. If a response is not received within this interval, the link level
controller increments this counter and then retransmits the command
with the P bit set to require an immediate response.
Managment
Information Base
18
Management Information Base Variables
cct: Circuits Information Base
18-17