Filter
Top Products
Remote signal & sense
timeout (sec)
Sets the timeout range for the Remote signal & sense feature. Smaller
values allow quicker detection of disabled lines and larger values reduce the
amount of line bandwidth needed.
Default: 50-60
Range: 5-6 to 165-198 (seconds)
Note: For the specified circuit, set Remote signal & sense timeout (sec) to
the same value in both routers connected to the circuit. Otherwise, the line
between the two routers may be unintentionally disabled.
Remote Station Number
Accepts the telephone number used by the terminal adapter when dialing
out to reach the remote router. This number can be up to 20 digits long,
depending upon your terminal adapter. You may also be able to include
some or all of the following symbols in the number string:
: << = >> P T &
If you leave this field blank, the router operates as a V.25 bis receive-only
unit.
Retry Counter (N2)
Determines the number of possible retransmissions of the same frame after
the Retry Timer (T1) interval elapses.
Default: 16 (seconds)
Retry Timer (T1}
Sets the time interval, in seconds, between issuing a command and receiving
an acknowledgment. In the absence of an acknowledgment, the router
retransmits the command when the T1 Timer elapses.
Default: 3
Note: This default is the recommended setting for the HP Remote Bridge
connection. The bridge and HP router should have the same setting.
Send CIC on all
allowed INC’s
Controls whether to send a ‘‘connect incoming call’’ (CIC) command in
response to any incoming call indication. Set this parameter to Yes only if
your adapter requires a CIC command.
Default: No
Yes
Enables the transmission of a CIC command.
No
Disables the transmission of a CIC command.
Circuit Parameters
Parameters and Options
4-26