Filter
Top Products
Invalid Configuration: Pt-to-Pt address must be DCE
Meaning: Auto-configuring has detected a remote bridge, but the router’s Pt-to-Pt
address configuration option is not set to DCE or auto-configure.
Action: Use DCE or auto-configure as the Pt-to-Pt address for the Point-to-Point
WAN circuit.
Invalid Configuration: Mismatching QOS
Meaning: The QOS configuration option for the Point-to-Point WAN circuit is not
the same on the local and remote device.
Action: Change to QOS configuration option to be the same or to use
auto-configure on either the local or the remote device.
Invalid Configuration: Use ’No Compression’
Meaning: Auto-configuring has detected a remote bridge and the router’s
compression configuration option is not set to ’No Compression’
or auto-configure.
Action: Use ‘‘No Compression’’ or auto-configure as the compression method for
the Point-to-Point WAN circuit.
Invalid Configuration: Pt-to-Pt addresses are equal
Meaning: The Pt-to-Pt address configuration option for the Point-to-Point WAN
circuit is the same on the local and remote device.
Action: Change to Pt-to-Pt address configuration option to be the different or
to use auto-configure on either the local or the remote device.
Invalid Configuration: Mismatching Compression
Meaning: The compression configuration option for the Point-to-Point WAN
circuit is not the same on the local and remote device.
Action: Change the compression configuration option to be the same or to use
auto-configure on either the local or the remote device.
Event Log
Messages
17
Event Log Messages
dls: Data Link Services Event Messages
17-71