Filter
Top Products
EN
Chapter 6 133
Configuring the printer for the network
at the printer control panel
You might need to configure certain network parameters on the
printer. You can configure these parameters from the printer control
panel, the embedded Web server, or for most networks, from the
HP Web JetAdmin software (or the HP LaserJet Utility for Macintosh).
The utilities are provided on the printing software CD-ROM that
comes with the printer.
Note The embedded Web server is a new printer feature from HP. For more
information about using the embedded Web server, see Appendix E.
For a complete list of supported networks and for instructions on
configuring network parameters from software such as the HP Web
JetAdmin software, see the HP JetDirect Print Server Administrator’s
Guide. The guide comes with printers in which an HP JetDirect print
server is installed.
This section contains the following instructions for configuring
network parameters from the printer control panel:
● configuring Novell NetWare frame type parameters
● configuring TCP/IP parameters
● configuring the Apple EtherNet phase parameters
● disabling unused network protocols
Configuring Novell NetWare frame type
parameters
The HP JetDirect print server automatically selects a NetWare frame
type. Select a frame type manually only when the print server selects
an incorrect frame type. To identify the frame type chosen by the
HP JetDirect print server, print a configuration page from the printer
control panel.