HP (Hewlett-Packard) 4550 Printer User Manual


 
136 Printer Interfaces
EN
9 If you keep
BOOTP=YES *
, the values for the TCP/IP parameters
will be provided by the BOOTP file, RARP, or DHCP and no other
TCP/IP configuration is necessary. Skip to step 17.
OR
Press V
ALUE
to change the value of the
BOOTP=
parameter.
BOOTP=NO
displays.
10 Press S
ELECT
to save the selection.
BOOTP=NO *
appears, and
you are prompted to configure each of the TCP/IP parameters.
11 Press I
TEM
to continue configuring.
IP BYTE 1=<value>> *
displays.
12 Press V
ALUE
until the value of the first byte of the IP address
displays.
13 Press S
ELECT
to save the value.
14 Repeat steps 12 and 13 to configure the remaining bytes of the IP
address.
15 Press I
TEM
to continue.
16 Repeat steps 12-15 to configure the subnet mask bytes (
SM
),
default gateway (
GW
), and timeout (
TIMEOUT
).
17 If you are finished, press G
O
to return the printer to the
READY
state.
OR
See the appropriate sections for other protocols that will be used.