HP (Hewlett-Packard) 4550 Printer User Manual


 
EN
Chapter 8 153
Printer control panel messages
The following table lists the printer control panel messages for this
printer. Printer messages with numeric prefixes are listed in numerical
order. Printer messages without numeric prefixes are listed in
alphabetical order.
Note Except when the printer is initially turned on, messages are displayed
in the display language selected in the printer control panel (such as
English, French, or Spanish).
Printer control panel messages
Message Description Recommended action
ACCESS DENIED
MENUS LOCKED
Displayed for approximately
5 seconds when a user attempts to
modifyamenuvaluewhilecontrol
panel locking is enabled.
No action required.
BAD DUPLEXER
CONNECTION
The duplex printing accessory is not
correctly installed.
Verify that the power cord is
connected to the duplex
printing accessory and that the
short power cord from the
duplex printing accessory is
connected to the printer.
If the error continues, verify that
the duplex printing accessory is
correctly installed.
CALIBRATING
The printer is executing an internal
color calibration. This process
should take approximately 90
seconds.
No action required.
CANCELING JOB
The printer is in the process of
canceling a print job. Incoming data
for the current job will be discarded.
No action required.
CANNOT DUPLEX
CHECK REAR BIN
alternates with
CANNOT DUPLEX CHECK
PAPER
The printer cannot duplex because
the rear output bin is open or the
media is not supported by the
duplex printing accessory.
Close the rear output bin. If the
bin is closed, verify that the
media is supported by the
duplex printing accessory. See
Supported media weights and
sizeson page 67.
CANNOT DUPLEX
CLOSE REAR BIN
The printer cannot duplex because
the rear output bin is open.
Close the rear output bin.