Filter
Top Products
EN
Chapter 3 81
Printing envelopes when TRAY 1 MODE=CASSETTE
For the best results when printing envelopes, Tray 1 should be
configured as
TRAY 1 MODE=CASSETTE
andthemediasizeshouldbe
set to the size corresponding to the correct envelope size.
1 Set the media size for Tray 1 in the printer control panel. (See
“
Configuring Tray 1 as a cassette” on page 76.)
2 Specify Tray 1 or select the media source by size (for example,
COM 10 or DL) in the printer driver.
3 If your software does not automatically format an envelope,
specify Landscape for page orientation in your software
application or printer driver. Use the following guidelines to set
margins for return and destination addresses on Commercial #10
or DL envelopes.
Note For envelopes of other sizes, adjust the margin settings appropriately.
4 Select Print from the software application or printer driver.
Printing envelopes when TRAY 1 MODE=FIRST
IfTray1isconfiguredas
TRAY 1 MODE=FIRST
(default), select
Tray 1 or use autoselect and then print the file from your software
application or the printer driver. In this mode, the printer will pull
media from the tray regardless of the size and type of media loaded. If
your software does not automatically format an envelope, follow the
instructions provided in the previous section.
Address Type Left Margin Top Margin
Return 15 mm (0.6 in) 15 mm (0.6 in)
Destination 102 mm (4.0 in) 51 mm (2.0 in)