HP (Hewlett-Packard) 4550 Printer User Manual


 
190 Solving problems with the printer
EN
Printer is on, but nothing prints
Cause Solution
The printers READY indicator light is not lit.
Press GO
to return the printer to the
READY
state.
The top cover is not closed properly. Close the top cover firmly, verifying that it is
properly latched.
The D
ATA
indicator is flashing. The printer is probably still receiving data. Wait
for the D
ATA
indicator to stop flashing.
[COLOR] TONER OUT
appears on the printer
display.
Replace the toner cartridge specified on the
printer display.
A printer message other than
READY
appears
on the printer control panel.
See Chapter 8
for an explanation of printer
control panel messages.
Your parallel port may have a DOS timeout
error.
Add a MODE command to your
AUTOEXEC.BAT file. See your DOS manual
for additional information.
The PS (PostScript Emulation) personality is
not selected.
Select
PS
or
AUTO
for the printer language (see
Chapter 2).
The correct driver is not selected in your
software application or printer driver.
Select the driver for PostScript Emulation for
this printer in your software application or
printer driver.
The printer is not properly configured. See Chapter 6
for configuration information.
The computer port is not configured or is not
working properly.
Run another peripheral connected to this port
to verify that the port is working properly.
The printer has not been correctly named for
your network or for a Macintosh computer.
Use the appropriate utility to name the printer
on the network. For Macintosh computers,
name the printer from within the Chooser
menu.