Filter
Top Products
5. Clean the glass strip with a soft cloth or sponge slightly moistened with a
nonabrasive glass cleaner.
Caution Do not use abrasives, acetone, benzene, or carbon
tetrachloride on the glass, since they can damage it. Do not place or spray
liquid directly on the glass. The liquid might seep under the glass and
damage the device.
6. Lower the automatic document feeder mechanism, and then close the cover of
the automatic document feeder.
7. Close the lid.
8. Plug in the power cord, and then turn on the HP All-in-One.
Clean the lid backing
Minor debris can accumulate on the white document backing located underneath the
lid of the HP All-in-One.
To clean the lid backing
1. Turn off the HP All-in-One, unplug the power cord, and raise the lid.
Note Depending how long the HP All-in-One is unplugged, the date and
time might be erased. You might need to reset the date and time later,
when you plug the power cord back in.
2. Clean the white document backing with a soft cloth or sponge slightly moistened
with a mild soap and warm water.
Wash the backing gently to loosen debris. Do not scrub the backing.
3. Dry the backing with a chamois or soft cloth.
Caution Do not use paper-based wipes, as these might scratch the
backing.
4. If further cleaning is needed, repeat the previous steps using isopropyl (rubbing)
alcohol, and wipe the backing thoroughly with a damp cloth to remove any
residual alcohol.
Caution Be careful not to spill alcohol on the glass or exterior of the
HP All-in-One, as this might damage the device.
User Guide
93
Maintain the HP All-in-One