Filter
Top Products
Using the Analyzer
To Inject Alarms and Errors
2-52
To Inject Physical Errors
The type of errors you can inject depends on the interface pods installed.
Watch the results of the injected alarms or errors. The number of alarm or
error cells injected is shown at the top of the Physical Alarms/Errors
window. If you are using an external loopback or transmit loopback mode,
you can also monitor the errors and alarms by watching the Alarm and
Error indicators at the top of the main screen.
1
Click the Errors tab.
3
Click the Inject
button each time you
want to inject a
single error.
3
Enter the rate at
which you want to
inject errors; then
click the On button
to start injecting
errors.
2
Select the type of
error to inject.
or