Filter
Top Products
Setting Up the Analyzer
To Connect the Analyzer to a Computer
1-6
To Connect the Analyzer to a Computer
The analyzer is designed for both onsite and remote broadband testing
applications. The way in which you connect the analyzer to a computer
depends on whether you want to perform remote or local testing. You can
connect the analyzer as a
• standalone system (with a notebook PC)
• networked system
• remote system (using a modem)
Both the HP Broadband Service Analyzer and the supplied notebook PC
are pre-configured for all of these connections (except for network
specific configuration parameters). For a networked system, you will need
to record additional information. See “To Connect the Analyzer as a
Networked System” on page 1-10.
The default configuration for the analyzer is as follows:
The default configuration for the notebook PC is as follows:
Boot source Local Disk
Ethernet IP Address 10.0.0.1
Ethernet IP Netmask 255.255.255.0
Host IP Address 10.0.0.2
Host Gateway IP Address not used
SLIP IP Address 10.0.1.1
Ethernet IP Address 10.0.0.2
Ethernet IP Netmask 255.255.255.0
SLIP IP Address 10.0.1.2