Filter
Top Products
Using the Analyzer
To Connect to the System Under Test
2-8
When using a non intrusive, T-piece connection, the interface
configuration of the analyzer is not important. The analyzer’s default
configuration is full duplex.
Diagnostic System Connection
A diagnostic connection does not affect the traffic on the link to which the
analyzer is connected. Use this connection when you want to test the
analyzer.
There are two diagnostic test connections available for the diagnostic
system connection:
• transmit loopback
• external loopback
You can connect any of the interface pods available with the analyzer in a
diagnostic system connection.
T-piece
Port 1
Port 2
Equipment under test
Tx
Rx
Tx
Rx