Filter
Top Products
EN
HP JetDirect Configuration Page Messages 115
Table 7.4 DLC/LLC Configuration Messages
Message Description
DLC/LLC STATUS: Current DLC/LLC status:
DISABLED: Indicates that DLC/LLC was manually disabled
through the printer's control panel (if available).
DISABLED: Indicates that LAN Server was manually
disabled through the printer's control panel (if available).
READY: Indicates the HP JetDirect print server is awaiting
data.
NOT IN USE: Code is in the middle of a download.
SERVER ADDRESS: Station address of the remote end of the connection.
Table 7.5 General HP JetDirect Messages (1 of 15)
Message Description
ARP DUPLICATE IP
ADDRESS
The ARP layer has detected another node on the network
using the same IP address as the HP JetDirect print server.
Extended error information below this message shows the
hardware address of the other node.
AUTONEGOTIATION
ON
OFF
Identifies whether IEEE 802.3 Autonegotiation on the
HP JetDirect 10/100TX port is enabled (ON) or disabled
(OFF). If ON, the HP JetDirect print server will attempt to
automatically configure itself onto the network at the proper
speed (10 or 100 Mbps) and mode (half or full duplex). If
OFF, you must manually configure the speed and mode
using switches or jumpers on the print server.
AUTO-REMOVAL
ERROR
The HP JetDirect print server detected an internal hardware
error following the Token Ring beacon auto-removal process
and has removed itself from the ring.
BABBLE ERROR Run the power-on self-test: turn the printer off, then on
again. If the error persists, replace the HP JetDirect print
server. For information on replacing your HP JetDirect print
server, see the hardware installation guide for your print
server.
BAD BOOTP REPLY An error was detected in the BOOTP reply that the
HP JetDirect print server received. The BOOTP reply either
had insufficient data in the UDP datagram to contain the
minimum BOOTP header of 236 bytes, had an operation
field that was not BOOTPREPLY(0X02), had a header field
that did not match the print servers hardware address, or
had a UDP source port that was not the BOOTP server port
(67/udp).