Filter
Top Products
EN
Troubleshooting the HP JetDirect Print Server 87
Procedure 3: Resolving Printer Display Error
Messages
Check the following information to resolve network related error
messages that appear on the printer control panel display.
This
information assumes you have already printed a configuration page.
1. Does 18 MIO NOT READY or 23 MIO NOT READY appear on the printer
display?
■
If you are using thin Ethernet coaxial cable, a cabling problem
has been detected. Verify the network cabling, connections,
and router configurations.
■
If you downloaded Flash images recently, turn off the printer,
then turn it back on.
■
Verify that the correct print server name appears next to
NODE
NAME on the configuration page. If not, see the chapter
for your network operating system for installation
information.
2. Does NOT READY, UPPER MIO, or LOWER MIO appear on the display?
■
Make sure that the print server is connected to the network.
■
See if any error messages appear on the configuration page.
See the end of this chapter for descriptions of the information
on the configuration pages or the chapter “HP JetDirect
Configuration Page Messages” for error message information.
3. Does EIO# INITIALIZING/DO NOT POWER OFF appear on the
display?
Wait for ten minutes to see if it clears. If it does not, you may
need to replace the HP JetDirect print server.