Filter
Top Products
46 TCP/IP Configuration
EN
To set configuration parameters, you must set up a Telnet
connection from your system to the HP JetDirect print server.
1. Type the following at the system prompt:
telnet <IP address>
where
<IP address>
may be the assigned address from
BOOTP, RARP, DHCP, the printer control panel, or the default
IP address. The default IP address is 192.0.0.192. The
<IP address>
is listed on the JetDirect configuration page.
2. When the server responds
connected to IP address
, press
[Enter]
twice to make sure that the Telnet connection is
initialized.
3. If you are prompted for a password, type the correct password.
By default, Telnet does not require a password, but you can set
up to a 14-character password by using the password command
(passwd). Once a password is set, password protection is
enabled. You can disable password protection by typing
0
(zero)
when prompted for a new password, or by performing a cold
reset on the print server.
Note Any time during the Telnet session you can type:
?
then press
[Enter]
to view available configuration
parameters, the correct command format, and a list
of additional commands to display. To print current
configuration information, type
/
then press
[Enter]
.