Filter
Top Products
32 TCP/IP Configuration
EN
contact: ASCII character string that identifies the person who
administers or services the printer (SNMP sysContact
object). This may include how to contact this person. The
default contact is undefined.
get-community-
name:
Specifies a password that determines which SNMP
GetRequests the HP JetDirect print server will respond
to. This is optional. The community name must be ASCII
characters. The maximum length is 32 characters.
set-community-
name:
Specifies a password that determines which SNMP
SetRequests (control functions) the HP JetDirect print
server will respond to. The community name of an
incoming SNMP SetRequest must match the print
server’s “set community name” for the print server to
respond. SetRequests must come from hosts that are
configured in the print server’s host access list.
Community names must be ASCII characters. The
maximum length is 32 characters.
trap-dest: Enters a host’s IP address into the HP JetDirect print
server’s SNMP trap destination list. If the list is empty,
the print server does not send SNMP traps. The list may
contain up to four entries. The default SNMP Trap
Destination List is empty. To receive SNMP traps, the
systems listed on the SNMP trap destination list must
have a trap daemon to listen to those traps.
trap-community
-name:
Community name (password) included with SNMP traps
that are sent by the HP JetDirect print server to a host
computer. The default community name is
public
.
Community names must be ASCII characters. The
maximum length is 32 characters.
authentication-
trap:
Configures the print server to send (on) or not send (off)
SNMP authentication traps. Authentication traps indicate
that an SNMP request was received, but the community
name check failed. The default is “off.” Newer
HP JetDirect EIO cards will not support the separate
SNMP authentification trap setting. (All SNMP traps will
be set in the SNMP Trap Destination List.)
Table 3.2 TFTP Configuration File Parameters (2 of 3)