HP (Hewlett-Packard) 600N Network Card User Manual


 
116 HP JetDirect Configuration Page Messages
EN
BAD BOOTP TAG SIZE The tagsize in a vendor specific field in the BOOTP reply is
either 0, or greater than the remaining number of
unprocessed bytes in the vendor specified area.
BAD LENGTH RCVD: Total number of frames missed because they were too long
for the HP JetDirect print server to receive.
BAD PACKETS RCVD: Total number of frames (packets) received by the
HP JetDirect print server with errors.
BOOTP/DHCP IN
PROGRESS
The HP JetDirect print server is currently in the process of
obtaining its basic IP configuration information through
BOOTP/DHCP, and has not detected any errors.
BURST ERRORS
RCVD:
Number of times the HP JetDirect Token Ring print server
could detect no transitions for 5 half-bit times between the
Start Delimiter (SD) and the End Delimiter (ED).
CF ERR - ACCESS
LIST EXCEEDED
The TFTP configuration file specified too many access list
entries using the “allow:” keyword.
CF ERR - FILE
INCOMPLETE
The TFTP configuration file contained an incomplete last
line that did not end in a newline character.
CF ERR - INVALID
PARAM
A line in the TFTP configuration file contained an invalid
value for one of the parameters on that line.
CF ERR - LINE TOO
LONG
A line being processed in the TFTP configuration file was
longer than the HP JetDirect print server could accept.
CF ERR - MISSING
PARAM
A line in the TFTP configuration file was missing a required
parameter.
CF ERR - TRAP LIST
EXCEEDED
The TFTP configuration file specified too many trap
destination list entries using the “trap-destination:” keyword.
CF ERR - UNKNOWN
KEYWORD
A TFTP configuration file line contained an unknown
keyword.
CONFIGURATION
ERROR
The configuration information for the NetWare functions is
not stored correctly on the HP JetDirect print server. Rerun
the installation software to reconfigure. If this error persists,
there may be a problem with the HP JetDirect print server.
CRC ERROR Check the network topology and verify all cable segments.
Check for damaged cables.
Table 7.5 General HP JetDirect Messages (2 of 15)
Message Description