Filter
Top Products
118 HP JetDirect Configuration Page Messages
EN
FIRMWARE
REVISION: X.XX.XX
The firmware revision number of the HP JetDirect print
server currently installed in the printer.
FRAME COPIED
RCVD:
Total number of Token Ring frames received with the frame
copy error indicated in the Frame Status (FS) field.
FRAMING ERROR Check the network topology and verify all cable segments.
Check for damaged cables.
FRAMING ERRORS
RCVD:
Maximum of CRC (Cyclic Redundancy Check) errors and
framing errors. CRC errors are frames received with CRC
errors. Framing errors are frames received with alignment
errors. A large number of framing errors could indicate a
cabling problem with your network.
FS SET ERRORS
RCVD:
Total number of Token Ring frames with frame status set
errors, indicating another node could not set the frame
status.
FUNCTION FAILURE The HP JetDirect print server is unable to transmit to itself
while wrapped through its lobe at the Token Ring wiring
concentrator. This message may also indicate that data
frames were received before physical insertion.
HARD ERROR The HP JetDirect print server is transmitting or receiving
beacon frames to or from the ring.
HP JETDIRECT
JXXXXX
Identifies the HP JetDirect print server model number.
INITIALIZING TRYING
TO CONNECT TO
SERVER
The HP JetDirect print server is trying to connect to the
NetWare server(s). This is a normal message. Wait until the
connection is established or another status message
appears.
INVALID GATEWAY
ADDRESS
The default gateway IP address specified for the
HP JetDirect print server (through BOOTP or NOVRAM) is
an invalid IP address for specifying a single node.
INVALID IP ADDRESS The IP address specified for the HP JetDirect print server
(through BOOTP or NOVRAM) is an invalid IP address for
specifying a single node.
INVALID SERVER
ADDRESS
The TFTP server IP address specified for the HP JetDirect
print server (through BOOTP) is an invalid IP address for
specifying a single node.
INVALID SUBNET
MASK
The IP subnet mask specified for the HP JetDirect print
server (through BOOTP or NOVRAM) is an invalid subnet
mask.
INVALID SYSLOG
ADDRESS
The syslog server IP address specified for the HP JetDirect
print server (through BOOTP) is an invalid IP address for
specifying a single node.
Table 7.5 General HP JetDirect Messages (4 of 15)
Message Description