Filter
Top Products
EN
HP JetDirect Configuration Page Messages 119
INVALID TRAP DEST
ADDRESS
One of the SNMP trap (Trap PDU) destination IP addresses
specified for the HP JetDirect print server (through TFTP)
is an invalid IP address for specifying a single node.
I/O CARD
INITIALIZING (INIT)
The HP JetDirect print server is initializing the network
protocols. For more information, see the network operating
system status line on the configuration page.
I/O CARD NOT READY There is a problem with the print server or its configuration.
Following the I/O CARD NOT READY message is a status
message. See this table for a detailed explanation of all
status messages.
I/O CARD READY The HP JetDirect print server is connected and awaiting
data.
LAN ERROR-AUTO
REMOVAL
Run the power-on self-test: turn the printer off, then on
again. If this message reappears on another configuration
page, you may have a problem with one of the HP JetDirect
print servers on your network. Check all the print servers on
the network for proper operation.
LAN ERROR-BABBLE Check the network connections. If the connections are
intact, run the power-on self-test: turn the printer off, then
on again. If the error persists, replace the HP JetDirect print
server. For replacement instructions, see the hardware
installation guide for your print server.
LAN
ERROR-CONTROLLE
R CHIP
Check the network connections. If the connections are
intact, run the power-on self-test: turn the printer off, then
on again. If the error persists, replace the HP JetDirect print
server. For replacement instructions, see the hardware
installation guide for your print server.
LAN
ERROR-EXTERNAL
LOOPBACK
The HP JetDirect print server is incorrectly connected to
your network or is defective. Make sure your HP JetDirect
print server is correctly attached to your network. In addition,
check the cabling and BNC “T” connectors.
LAN ERROR-INFINITE
DEFERRAL
There is a network congestion problem. For coaxial cable
networks, verify that the network cable is properly
terminated.
Note:
If the print server is not connected to the network, this
error cannot occur.
LAN
ERROR-INTERNAL
LOOPBACK
Check the data rate switch on the HP JetDirect print server
to make sure it is set correctly. For information on setting the
data rate switch, see the hardware installation guide for your
print server. In addition, check the cabling, external
transceiver, wiring concentrator, and taps.
Table 7.5 General HP JetDirect Messages (5 of 15)
Message Description