Filter
Top Products
EN
TCP/IP Configuration 45
Using Telnet
This subsection describes how to configure the print server
using Telnet.
Note To use Telnet commands with the HP JetDirect
print server, a route must be available from your
workstation to the print server. Simplistically, this
means that there must be a match between the
network identification of your system to that of the
HP JetDirect print server.
On Windows 95/98 and NT/2000 systems, you can
use the following
route
command at a DOS prompt
to add a route to the print server:
route add
<IP address JetDirect>
<IP address workstation>
where
<IP address JetDirect>
is the IP address
configured on the HP JetDirect print server, and
<IP address workstation>
is the IP address of
the workstation's network card that is attached to
the same physical LAN as the print server.
CAUTION Using Telnet to change dynamically-configured
JetDirect print servers (for example, using BOOTP,
RARP, DHCP), may result in a static configuration
depending on the parameter being changed.