Filter
Top Products
EN
Printing on Windows NT DLC/LLC Networks 145
Configuring a Printer
Before you configure your printer, make sure that the following
tasks have been performed:
●
Internal print servers: The print server is installed in the printer
and the printer is connected to a network.
●
External print servers: The print server has power and is
connected to the printer’s parallel port and network.
●
The printer is turned on, is online, and you have printed a
JetDirect configuration page.
If you have not printed a configuration page from your printer, see
the hardware installation guide for your print server or your
printer’s getting started guide for instructions.
To Configure the Printer (Windows NT 4.0)
1. From the Windows NT desktop, click
Start
,
Settings
, then
Printers
.
2. Double-click
Add Printer
.
3. Select
My Computer
and then click
Next
. The
Add Printer
Wizard
appears.
4. Click on
Add Port
.
5. Double-click on
Hewlett-Packard Network Port
.
6. Type a name for the port in the
Name
box. The name must not
be the name of an existing port, such as LPT1, or an existing
DOS device.
7. Select the HP JetDirect LAN HARDWARE address from the
Card Address
pull down menu or type the correct address. This
address must match the one listed under “LAN HW ADDRESS”
on the configuration page.
8. Click
Close
.
The list of ports is displayed and the newly created port will be
checked.
9. Click
Next
.