Filter
Top Products
52 TCP/IP Configuration
EN
Using the Printer Control Panel
This subsection describes how to configure the HP JetDirect
internal print server using the printer's control panel.
If configuration of the HP JetDirect print server is supported from
your printer control panel, you can set the network configuration
parameters listed below.
●
IP address of the print server
●
Subnet mask
●
Default gateway address
●
Syslog server address
●
Idle timeout period
If the printer control panel configuration is supported, see the
hardware installation guide for your print server or the user guide
for your printer for instructions on how to configure the print server
from the printer control panel.
If you need to configure other parameters, use BOOTP/TFTP to
configure all the parameters for the print server.
If the HP JetDirect print server is configured to receive its
configuration from the printer control panel, the configuration is
saved on the print server over power cycles. For information on
these parameters see Table 3.4.