Filter
Top Products
120 HP JetDirect Configuration Page Messages
EN
LAN ERROR-JUMPER The data rate switch on the HP JetDirect print server is set
incorrectly. For instructions on setting the data rate switch,
see the hardware installation guide for your print server.
LAN ERROR-LOSS OF
CARRIER
Check the network connections. If the connections are
intact, run the power-on self-test: turn the printer off, then
on again. If the error persists, replace the HP JetDirect print
server. For replacement instructions, see the hardware
installation guide for your print server.
LAN ERROR-NO
LINKBEAT
With a 10/100 Base-T port connected, this message is
displayed if Link Beat is not sensed. Check the network
cable, and verify that the concentrator/hub is providing Link
Beat.
LAN ERROR-NO SQE Check the network connections. If the connections are
intact, run the power-on self-test: turn the printer off, then
on again. If the error persists, replace the HP JetDirect print
server. For replacement instructions, see the hardware
installation guide for your print server.
LAN ERROR-OPEN The HP JetDirect print server could not insert into the ring
and join the network. Check the data rate switch on the
HP JetDirect print server to make sure it is set correctly.
For information on setting the data rate switch, see the
HP JetDirect internal print server hardware installation
guides. In addition, check the cabling, external transceiver,
wiring concentrator, and taps.
LAN
ERROR-RECEIVER
OFF
There may be a problem with your network cabling or the
HP JetDirect print server. Check the cabling and BNC “T”
connectors on your Ethernet network. If you cannot find a
problem with your network cabling, run the power-on
self-test: turn the printer off, then on again. If the error
persists after the printer is turned on again, there is a
problem with the HP JetDirect print server.
LAN ERROR-REMOVE
RECEIVE
Run the power-on self-test: turn the printer off, then on
again. If this message reappears on the resulting
configuration page, you may have a problem with one of the
HP JetDirect print servers on your network. Check all the
HP JetDirect print servers on the network for proper
operation.
LAN ERROR-RETRY
FAULTS
There is a problem with your network cabling or external
network configuration. Make sure that your network cable is
correctly terminated at both ends. Verify operation of the hub
or switch port.
Table 7.5 General HP JetDirect Messages (6 of 15)
Message Description