Filter
Top Products
EN
HP JetDirect Configuration Page Messages 121
LAN
ERROR-TRANSMITTE
R OFF
There may be a problem with your network cabling or the
HP JetDirect print server. Check the cabling and BNC “T”
connectors on your Ethernet network. If you cannot find a
problem with your network cabling, run the power-on
self-test: turn the printer off, then on again. If the error
persists, there is a problem with the HP JetDirect print
server.
LAN
ERROR-UNDERFLOW
There may be a problem with your network cabling or the
HP JetDirect print server. Check the cabling and BNC “T”
connectors on your network. If you cannot find a problem
with your network cabling, run the power-on self-test: turn
the printer off, then on again. If the error persists, there is a
problem with the HP JetDirect print server.
LAN ERROR-WIRE
FAULT
There is a problem with the network cabling. Check the
cabling between the printer and the network.
LAN HW ADDRESS:
XXXXXXXXXXXX
The 12-digit hexadecimal network address of the
HP JetDirect print server installed in the printer.
LATE COLLISION
ERROR
Check the network topology, verify all cable segments, and
make sure no segment is too long.
LINE ERRORS RCVD: Total number of Token Ring frames received by the
HP JetDirect print server with code violations or CRC
(Cyclic Redundancy Check) errors. A large number may
indicate faulty cabling on your network.
LOBE WIRE FAULT The HP JetDirect print server has detected an open or short
circuit in the cable between the HP JetDirect print server
and the Token Ring wiring concentrator. Verify that this cable
is functional and replace it if necessary.
LOSS OF CARRIER
ERROR
Check the network connections. If the connections are
intact, run the power-on self-test: turn the printer off, then
on again. If the error persists, replace the HP JetDirect print
server. For replacement instructions, see the hardware
installation guide for your print server.
LOST FRAMES: Number of times the end of the frame could not be detected
while transmitting.
MEMORY ERROR Run the power-on self-test: turn the printer off, then on
again. If the error persists, replace the HP JetDirect print
server. For replacement instructions, see the hardware
installation guide for your print server.
MFG ID: The manufacturing identification code.
NDS
AUTHENTICATION
ERROR
Unable to log onto the NetWare directory tree. Make sure
that the print server object is defined in the directory at the
correct context.
Table 7.5 General HP JetDirect Messages (7 of 15)
Message Description