Filter
Top Products
Page 4-13CHAPTER 4 PROGRAMMABLE FUNCTION STRINGS
13 P PSCPI
Print with proportional spacing in portrait orientation. This PFS is sent to
the printer when the 5250 ALLYs page orientation algorithm has selected
a portrait orientation, and when the System has requested proportional
spacing (using either an SCS Set Character Density command or an SCS
Set FID through GFID command).
If the printer is capable of printing any font with proportional spacing, then
this PFS should set proportional spacing for the current font. If a specific
font is needed to achieve proportional spacing, then this PFS should be
defined to select that font.
If Option 4F CPI/Font Order is set to 00 (!AGILE!4F=00;), then this
PFS will be sent before the GFID for the font is sent. If Option 4F CPI/
Font Order is set to 01 (!AGILE!4F=01;), then this PFS will be sent after
the GFID for the font is sent.
14 P 12CPI
Print 12 characters per inch in portrait orientation. This PFS is sent to the
printer when the 5250 ALLYs page orientation algorithm has selected a
portrait orientation, and when the System has requested a font with a pitch
of greater than 10 but less than or equal to 12 CPI (using either an SCS Set
Character Density command or an SCS Set FID through GFID command).
If the printer is capable of printing any font at any pitch (CPI), then this
PFS should set the pitch for the current font. If a specific font is needed to
achieve 12 CPI, then this PFS should be defined to select that font.
If Option 4F CPI/Font Order is set to 00 (!AGILE!4F=00;), then this
PFS will be sent before the GFID for the font is sent. If Option 4F CPI/
Font Order is set to 01 (!AGILE!4F=01;), then this PFS will be sent after
the GFID for the font is sent.
15 P 15CPI
Print 15 characters per inch in portrait orientation. This PFS is sent to the
printer when the 5250 ALLYs page orientation algorithm has selected a
portrait orientation, and when the System has requested a font with a pitch
of greater than 12 but less than or equal to 15 CPI (using either an SCS Set
Character Density command or an SCS Set FID through GFID command).