Filter
Top Products
AGILE 5250 ALLY Users Guide and ReferencePage 2-4
Configuration Defaults
The 5250 ALLY is shipped from the factory with a given set of parameters
called defaults. The default configuration will allow most operators to
use the 5250 ALLY after making few, if any, configuration changes. These
factory defaults, including the default programmable function strings and
translation tables, can be restored at any time by sending the trigger
followed directly by the terminator, as shown:
!AGILE!;
To reset an individual configuration parameter to its default setting, enter
the trigger, the option number and the terminator. The following example
sets the twinax host Xerox PFS suppression value to its default setting
(note that this is one of the four-digit options):
!AGILE!0601;
Note: Xerox special options are described in Appendix A Interfacing
Xerox Printers.
Power-On Reset
If the user has made configuration changes and would like the unit to
return to its previous configuration, the user can cancel any unsaved
changes and return the unit to its former power-on state with the following
command:
!AGILE!=POR;
Save Configuration
After making any configuration changes, unless the changes are to be
temporary, the user must save the configuration to the 5250 ALLY flash
memory with the following command:
!AGILE!=SAVE;