Filter
Top Products
Page 4-25CHAPTER 4 PROGRAMMABLE FUNCTION STRINGS
3E LPAPER 3
Use paper from source/drawer 3. This PFS is sent to the printer at the
beginning of each landscape page when the System has sent an SCS Page
Presentation Media command with the sd parameter set to 03h. It uses
format information from Option 57 Paper 3.
3F L ENVEL
Use paper from source/drawer 4. This PFS is sent to the printer at the
beginning of each landscape page when the System has sent an SCS Page
Presentation Media command with the sd parameter set to 04h. It uses
format information from Option 58 Envelope.
40 LANDCUT
Use cut feed paper (sheet feed). PORTCUT and LANDCUT are the only
settings allowed by the System if the printer is configured as an IBM 3812
laser printer (!AGILE!02=00;). If the System specifies cut feed paper with
the SCS Set Printer Setup command, and if the printer is in landscape
mode, then this PFS will be sent to the printer. Afterward, one of the
drawer-select PFSs above will be sent to select the paper source drawer.
41 LANDTRC
Use tractor feed paper. If the System specifies tractor feed with the SCS
Set Printer Setup command, and if the printer is in landscape mode, then
this PFS will be sent to the printer. If the printer has more than four paper
drawers, this PFS can be used to allow access to a fifth paper drawer.
However, automatic orientation selection works only for PFSs 35-38 and
3C-3F. It does not work for LANDTRC.
42 LANDMAN
Use manual feed paper (sheet feed). If the System specifies manual feed
with the SCS Set Printer Setup command, and if the printer is in landscape
mode, this PFS will be sent to the printer. If the printer has more than four
paper drawers, this PFS can be used to access a fifth or sixth drawer.
However, automatic orientation selection works only for PFSs 35-38 and
3C-3F. It does not work for LANDMAN.