Filter
Top Products
AGILE 5250 ALLY Users Guide and ReferencePage 4-26
43 JOG OUT
Move paper output tray to the other position (when the printer can output
paper to two positions). This is sometimes referred to as output offsetting.
This PFS is sent to the printer at the beginning of each page that requires
an offset when the System has sent an SCS Set Initial Conditions command
with the ic parameter set to FFh (DP), when the System has sent an SCS
Page Presentation Media command with the do parameter set to a value
other than 00h, or when the System has sent an SCS Page Presentation
Media command with the dd parameter changed from its last setting.
44 DEST1
Select paper output drawer 1. This PFS is sent to the printer at the
beginning of each page when the System has selected paper output tray
number 1 with the SCS Page Presentation Media command.
45 DEST2
Select paper output drawer 2. This PFS is sent to the printer at the
beginning of each page when the System has selected paper output tray
number 2 with the SCS Page Presentation Media command.
46 DEST3
Select paper output drawer 3. This PFS is sent to the printer at the
beginning of each page when the System has selected paper output tray
number 3 with the SCS Page Presentation Media command.
4B JOBSTRT
Prepare the printer to receive a new print job. This PFS is sent to the
printer when the System declares that a new print job is about to start
(upon receipt of an SCS Set Initial Conditions command). Some of the
potential uses for this PFS are:
1)Declare a new print job at the printer to allow job offsetting,
spooling and/or duplexing to occur properly.
2)Set default formatting settings at the printer.
3)Perform a Form Feed to cause a blank page between jobs.