Inter-Tel CS-5400 Server User Manual


 
Administrator Procedures
INTER-TEL
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.1 August 2005
Station Programming
Page 29
b. Endpoint Information: This option allows you to select an Attendant for the end-
point or program the endpoint’s username. To select it, press or the
ENDPOINT
INFO
menu button. The display shows ENTER ENDPOINT INFO OPTION. Select
one of the following:
1.) Attendant: To assign an Attendant to serve this endpoint, press or the
ATTENDANT menu button. The display shows ENTER ATTENDANT
EXTENSION. Enter the desired extension number. When the circuit informa-
tion is displayed, press again to return to the ENTER ENDPOINT INFO
OPTION prompt. The display shows DATABASE UPDATED. (Or, to cancel
your entry, press or
CANCEL. The display shows NO UPDATE PER-
FORMED.)
2.) Username: To change the username of the endpoint, press or the
USER-
NAME
menu button. The display shows ENTER USERNAME. Enter the new
name as described on page 26. (Or, to cancel your entry, press or
CAN-
CEL
. The display shows NO UPDATE PERFORMED.)
c. Toll Restriction: This option allows you to set the endpoint class of service for day
and/or night modes. To select it, press or the
TOLL RESTRICTION menu but-
ton. Then do the following:
1.) The display shows TOLL RESTRICTION OPTION. Press or the
COS
DAY menu button to program day mode toll restriction. Or, press or the
COS NIGHT menu button to program night mode toll restriction.
2.) The display shows SET DAY (or NIGHT) COS XX. If this is not the COS
you want to program, scroll to the correct COS by pressing the high end of
the Volume button or
NEXT to scroll forward, or press the low end of the Vol-
ume button or
PREVIOUS to scroll backward. For more information about
COS, refer to page 158.
The default COS numbers are provided in Table .
3.) When the correct COS is displayed, press or the ON menu button to
enable the toll restriction. Or, press or the
OFF menu button to disable it.
4.) If desired, repeat preceding step 2 and step 3 to program additional COS toll
restrictions.
5.) Press or
ACCEPT to save the COS programming. The display shows
DATABASE UPDATED and then returns to the TOLL RESTRICTION
OPTION prompt.
6.) Press again to exit to the ENTER ENDPOINT OPTION prompt.
6. When the display shows ENTER ENDPOINT OPTION, press again to exit to the
ENTER ENDPOINT EXTENSION prompt. You can then program another endpoint by
repeating these steps or press or
ACCEPT once more to exit to the ENTER DATA-
BASE OPTION prompt.
7. When finished with all programming, press while the ENTER DATABASE
OPTION prompt is displayed. This ends the programming session.
Table 5: Default Class of Service (COS) Numbers
COS 02 – Deny Area/Office COS 06 – Deny Equal Access
COS 03 – Deny Operator COS 07 – Deny Local Calls
COS 04 – Deny Toll Access COS 08 – Denied Numbers
COS 05 – Deny International COS 09 – Allowed Numbers
2
1
#
2
3
1
2
1
2
#
#
#
#
#