Filter
Top Products
TROUBLESHOOTING
1-141August 9, 2005
D SERIES CONTROLLER
TROUBLESHOOTING AND COMPONENT REPLACEMENT
K
a
a
aw
s
k
ERROR CODE E6007 Wrist can’t be straightened any more (Singular point 1).
The posture of JT5 is set too close to 0 degrees (or a multiple of 360 degrees) on a
robot equipped with a 3S type wrist.
This does not normally occur in joint mode, but may oc-
cur with conveyor synchronous function enabled.
⇒
Change wrist posture
.
⇒
Move the robot in joint interpolation.
⇒
Change the wrist posture before enabling conveyor synchronous function, to prevent
this error.
_____________________________________________________________________
ERROR CODE E6008 Wrist can’t be bent any more. (Singular point 2).
The posture of JT5 is set too close to 180 degrees (or multiple of ±360 degrees) on a
robot equipped with a 3S wrist.
This does not normally occur in joint mode, but may oc-
cur with conveyor synchronous function enabled.
⇒
Change wrist posture
.
⇒
Move the robot in joint interpolation.
⇒
Change the wrist posture before enabling conveyor synchronous function, to prevent
this error.
_____________________________________________________________________
NOTE
NOTE