Lexmark 102 Printer User Manual


 
CAUTION:
Make sure the machine is turned Off (O) before you
connect or disconnect the power cord or other cables.
If the machine has cables other than the power cord,
you must connect them before you plug the power cord
into an outlet. You must first unplug the power cord
from the outlet when you remove the other cables.
If the cable between the printer and host computer is not
installed, find out when it will be installed. Connect the cables to
the printer only when instructed to do so by your system
supervisor.
4. Changing Your System/36 Configuration.
Auto Configuration will configure the printer as an IPDS* printer.
Other parameters are automatically assigned by the system.
Auto configuration is valid only for local printers. Remote printers
must be manually configured.
To modify the System/36 configuration for the 4230 Printer, see
Adding or Deleting Local Display Stations and Printers and
Adding or Deleting Remote Work Stations in Changing Your
System Configuration, SC21-9082.
The printer can be used as a local or remote IPDS printer. Use
the PH device code (IPDS Printer Universal Device Code).
There is no specific 4230 device code.
If the printer is to be used as a remote printer, it can be
configured to an IBM 5394 or 5294 Remote Control Unit.
2-16 Users Guide