Lexmark 102 Printer User Manual


 
The printer displays
or a status code and message, and the Ready indicator is Off. See
Ready Indicator on page 3-12 for more information.
NOT READY <A>
Forms
You can use two types of forms (paper) in your printer:
Continuous forms (F1 and F2 forms devices)
Cut forms (F3 and F4 forms devices).
The forms may be blank or preprinted. The forms may be single-part
or multiple-part, with or without carbon paper.
Keep in mind the following as you work with forms:
Inspect all forms for damage.
Do not use stapled, torn, or wrinkled forms.
When you use forms directly from a box, remove the box tops;
or, preferably, remove the forms from the box. Rough box-top
edges can damage the forms or cause the forms to jam.
All multiple-part cut forms must be glued at the top edge.
A maximum of four-part forms is recommended for the best
registration, feeding, and stacking. You might be able to use
five- or six-part forms, but test them before ordering large
quantities.
Humidity affects forms feeding and stacking. Keep all forms in a
cool, dry place. If the forms are exposed to high humidity, allow
them to adjust to the humidity level of the printer area for
approximately 24 hours before you use them.
3-18 Users Guide