Filter
Top Products
Using the Printer Verification Test for the F1 Forms
Device
To run the printer verification test, follow these steps:
1. Turn the power On (|) if not already on.
2. Wait until the printer displays
3. Press Stop.
The printer displays
and then on Models 102, 1I1, and 4I3 you may see
or on Models 202, 2I1, and 5I3 you may see
While on Models 4I3 and 5I3 (when parallel or serial is the
active interface) you may see
Ignore these messages until you have attached the printer to
your computer. (Press Stop to turn off the alarm, if necessary.)
4. Press Test.
READY <A>
NOT READY <A>
15 COMMUNICATIONS CHECK
CHECK CABLE
28 COMMUNICATIONS CHECK
CALL SYSTEM OPERATOR
29 LINK ERROR
Chapter 1. Setting Up the 4230 Printer 1-33