Filter
Top Products
339
CHAPTER 7 PROGRAMMING
7
7.2 When Using the Module in a Standard System Configuration
7.2.3 When performing the heating-cooling control
Cooling method
setting
Set the method for the cooling
control in the heating-cooling
control.
0: Air Cooled 0: Air Cooled 0: Air Cooled 0: Air Cooled
Cooling control
output cycle setting
Set the pulse cycle (ON/OFF
cycle) of the transistor output.
30s 0s 30s 30s
Overlap/dead band
setting
Configure the overlap/dead
band setting.
-0.3% 0.0% 0.0% 0.0%
Alert 1 mode setting Set the alert mode.
1: Upper Limit
Input Alert
0: Not Warning 0: Not Warning 0: Not Warning
Alert set value 1
Set the temperature where
CH Alert 1 (b8 of Un\G5 to
Un\G8) turns on.
250°C 0°C 0°C 0°C
Item Description
Set value
CH1 CH2 CH3 CH4