Filter
Top Products
I
4
4
7
8
419
CH Heating upper limit output limiter (Un\G42, Un\G74,
Un\G106, Un\G138) . . . . . . . . . . . . . . . . . . . . . .110
CH Input range (Un\G32, Un\G64, Un\G96, Un\G128)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .96
CH Integral time (I) setting (Un\G36, Un\G68,
Un\G100, Un\G132)
. . . . . . . . . . . . . . . . . . . . . .107
CH Loop disconnection detection dead band (Un\G60,
Un\G92, Un\G124, Un\G156)
. . . . . . . . . . . . . . . .125
CH Loop disconnection detection judgment time
(Un\G59, Un\G91, Un\G123, Un\G155) . . . . . . . . . 124
CH Lower limit output limiter (Un\G43, Un\G75,
Un\G107, Un\G139) . . . . . . . . . . . . . . . . . . . . . .110
CH Lower limit setting limiter (Un\G56, Un\G88,
Un\G120, Un\G152)
. . . . . . . . . . . . . . . . . . . . . .122
CH MAN output setting (Un\G51, Un\G83, Un\G115,
Un\G147) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .118
CH Manipulated value (MV) (Un\G13 to Un\G16)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .89
CH Manipulated value (MV) for output with another
analog module (Un\G177 to Un\G180)
. . . . . . . . .133
CH Manipulated value for cooling (MVc) (Un\G704 to
Un\G707) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 89
CH Manipulated value for heating (MVh) (Un\G13 to
Un\G16)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .89
CH Manipulated value of cooling (MVc) for output with
another analog module (Un\G708 to Un\G711)
. . . .133
CH Manipulated value of heating (MVh) for output with
another analog module (Un/G177 to Un\G180). . . .133
CH Manual reset amount setting (Un\G724, Un\G740,
Un\G756, Un\G772) . . . . . . . . . . . . . . . . . . . . . .152
CH Number of moving averaging (UnG698 to UnG701)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .151
CH Output variation limiter setting (Un\G44, Un\G76,
Un\G108, Un\G140) . . . . . . . . . . . . . . . . . . . . . .112
CH Overlap/dead band function (Un\G723, Un\G739,
Un\G755, Un\G771) . . . . . . . . . . . . . . . . . . . . . .152
CH PID control forced stop instruction (YnC to YnF)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .58
CH Primary delay digital filter setting (Un\G48, Un\G80,
Un\G112, Un\G144) . . . . . . . . . . . . . . . . . . . . . .115
CH Process value (PV) scaling function enable/disable
setting (Un\G725, Un\G741, Un\G757, Un\G773)
. .152
CH Process value (PV) scaling lower limit value
(Un\G726, Un\G742, Un\G758, Un\G774)
. . . . . . . 153
CH Process value (PV) scaling upper limit value
(Un\G727, Un\G743, Un\G759, Un\G775) . . . . . . . 153
CH Process value (PV) scaling value (Un\G728,
Un\G744, Un\G760, Un\G776)
. . . . . . . . . . . . . . . 153
CH Proportional band (P) setting (Un\G35, Un\G67,
Un\G99, Un\G131)
. . . . . . . . . . . . . . . . . . . . . . .105
CH Self-tuning flag (Un\G575, Un\G607, Un\G639,
Un\G671)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .147
CH Self-tuning setting (Un\G574, Un\G606, Un\G638,
Un\G670) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .146
CH Sensor correction value setting (Un\G45, Un\G77,
Un\G109, Un\G141) . . . . . . . . . . . . . . . . . . . . . .113
CH Sensor two-point correction gain latch completion
(UnG551, UnG583, UnG615, UnG647)
. . . . . . . . .145
CH Sensor two-point correction gain latch request
(UnG550, UnG582, UnG614, UnG646) . . . . . . . . .144
CH Sensor two-point correction gain value (corrected
value) (UnG547, UnG579, UnG611, UnG643) . . . .143
CH Sensor two-point correction gain value (measured
value) (UnG546, UnG578, UnG610, UnG642)
. . . .143
CH Sensor two-point correction offset latch completion
(UnG549, UnG581, UnG613, UnG645). . . . . . . . . 144
CH Sensor two-point correction offset latch request
(UnG548, UnG580, UnG612, UnG644). . . . . . . . . 144
CH Sensor two-point correction offset value (corrected
value) (UnG545, UnG577, UnG609, UnG641)
. . . . 142
CH Sensor two-point correction offset value (measured
value) (UnG544, UnG576, UnG608, UnG640)
. . . . 142
CH Set value (SV) monitor (Un\G25 to Un\G28) . . 93
CH Set value (SV) setting (Un\G34, Un\G66, Un\G98,
Un\G130)
. . . . . . . . . . . . . . . . . . . . . . . . . . 104,195
CH Setting change rate limiter (temperature drop)
(Un\G564, Un\G596, Un\G628, Un\G660) . . . . . . . 119
CH Setting change rate limiter (temperature rise)
(Un\G52, Un\G84, Un\G116, Un\G148). . . . . . . . . 119
CH Setting change rate limiter (Un\G52, Un\G84,
Un\G116, Un\G148)
. . . . . . . . . . . . . . . . . . . . . . 119
CH Setting change rate limiter time unit setting
(Un\G735, Un\G751, Un\G767, Un\G783) . . . . 93,157
CH Simultaneous temperature rise AT mode selection
(Un\G733, Un\G749, Un\G765, Un\G781)
. . . . . . . 155
CH Simultaneous temperature rise dead time
(Un\G732, Un\G748, Un\G764, Un\G780)
. . . . . . . 155
CH Simultaneous temperature rise gradient data
(Un\G731, Un\G747, Un\G763, Un\G779) . . . . . . . 154
CH Simultaneous temperature rise group setting
(Un\G730, Un\G746, Un\G762, Un\G778) . . . . . . . 154
CH Simultaneous temperature rise status (Un\G734,
Un\G750, Un\G766, Un\G782)
. . . . . . . . . . . . . . . 156
CH Stop mode setting (Un\G33, Un\G65, Un\G97,
Un\G129). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 103
CH Temperature conversion setting (Un\G695 to
Un\G697). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 150
CH Temperature process value (PV) (Un\G9 to
Un\G12)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 89
CH Temperature process value (PV) for input with
another analog module (Un\G689 to Un\G692) . . . 150
CH Temperature rise judgment flag (Un\G17 to
Un\G20) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 91
CH Transistor output flag (Un\G21 to Un\G24) . . . 92
CH Unused channel setting (Un\G61, Un\G93,
Un\G125, Un\G157)
. . . . . . . . . . . . . . . . . . . . . . 126
CH Upper limit output limiter (Un\G42, Un\G74,
Un\G106, Un\G138)
. . . . . . . . . . . . . . . . . . 110,158
CH Upper limit setting limiter (Un\G55, Un\G87,
Un\G119, Un\G151) . . . . . . . . . . . . . . . . . . . . . . 122
CH Auto tuning status (Xn4 to Xn7) . . . . . . . . . . 364
CH Set value (SV) monitor (Un\G25 to Un\G28)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 195
Cold junction temperature compensation accuracy:
(ambient temperature: 0 to 55°C) . . . . . . . . . . . . . . 38
Cold junction temperature compensation resistor
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 278,282
Cold junction temperature compensation selection
(Un\G182)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 135
Cold junction temperature process value (Un\G29)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 93
Comparison of the functions between the Q64TCN and
the Q64TC. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 375
Compatibility . . . . . . . . . . . . . . . . . . . . . . . . . . . 377
Compensation lead wire . . . . . . . . 288,289,290,291
Condition for alert judgment. . . . . . . . . . . . . . . . . 203
Condition to be able to perform PID control . . . . . . 170