Filter
Top Products
380
*1 When a value other than 0 to 4 is set, a switch setting error (error code: 000F
H
) occurs. In this case, the Q64TCN does
not operate properly. Set the correct value. Immediately after the control mode selection is changed, a set value
discrepancy error (error code: 001E
H
) occurs. To clear the set value discrepancy error, turn off, on, and off E
2
PROM
backup instruction (Yn8).
*2 Control in the expanded mode requires an external output module. For the system configuration in expanded mode,
refer to Page 164, Section 4.1 (3).