Filter
Top Products
407
APPENDICES
A
Appendix 5 Online Module Change Procedure (When Using GX Works2)
Appendix 5.5 When parameters were configured using GX Works2
(3) Mounting a new module
(4) Checking operation
1. Mount a new module in the same slot and connect
the external cable.
2. After the module is mounted, click , and
check that the RUN LED is on. Module READY flag
(Xn0) remains off.
1. To check the operation, click to cancel
the control start.
2. Click to stop the "Online module
change" mode.
(To the next page)