Filter
Top Products
7000 Series L3 Managed Switch Reference Manual for Software v2.0
Switching Commands 7-51
config spanningtree configuration revision
This command sets the Configuration Identifier Revision Level for use in identifying the
configuration that this switch is currently using. The <revision> is a number in the range of 0 to
65535.
Default 0
Format config spanningtree configuration revision
<0-65535>
show spanningtree port
This command displays the settings and parameters for a specific switch port within the common
and internal spanning tree. The <slot.port> is the desired switch port.
Format show spanningtree port <slot.port>
Port mode Enabled or disabled.
Port Up Time Since
Counters Last Cleared
Time since port was reset, displayed in days, hours, minutes, and
seconds.
STP BPDUs Transmitted Spanning Tree Protocol Bridge Protocol Data Units sent
STP BPDUs Received Spanning Tree Protocol Bridge Protocol Data Units received.
RST BPDUs Transmitted
Rapid Spanning Tree Protocol Bridge Protocol Data Units sent
RST BPDUs Received Rapid Spanning Tree Protocol Bridge Protocol Data Units
received.
MSTP BPDUs Transmitted Multiple Spanning Tree Protocol Bridge Protocol Data Units sent
MSTP BPDUs Received Multiple Spanning Tree Protocol Bridge Protocol Data Units
received.
config spanningtree port bpdumigrationcheck
This command forces the specified port to transmit RST or MST BPDUs. The port <slot.port> is
the desired switch port. To set the migration check for all ports with a single command, "all" can
be specified. Note that the forceversion parameter for the switch must be set to 802.1w or 802.1s.
Default disable
Format config spanningtree port bpdumigrationcheck
<slot.port/all> <enable/disable>