Filter
Top Products
7000 Series L3 Managed Switch Reference Manual for Software v2.0
7-24 Switching Commands
config forwardingdb agetime
This command configures the forwarding database address aging timeout. In an IVL system, the
[fdbid/all] parameter is required. In an SVL system, the [fdbid/all] parameter is not used and will
be ignored if entered.
Default The default value for <10-1,000,000> is 300 seconds
Format config forwardingdb agetime <10-1,000,000>
[fdbid/all]
Seconds The <seconds> parameter must be within the range of 10 to
1,000,000 seconds.
Forwarding Database ID Fdbid (Forwarding database ID) indicates which forwarding data-
base's aging timeout is being configured. All is used to configure
all forwarding database's agetime. In an SVL system, the [fdbid/
all] parameter is not used and will be ignored if entered.
Device Configuration Commands
This section describes device configuration commands.
show switchconfig
This command displays switch configuration information.
Format show switchconfig
Broadcast Storm
Recovery Mode
May be enabled or disabled by selecting the corresponding line
on the pull-down entry field. The factory default is disabled.
802.3x Flow Control Mode May be enabled or disabled by selecting the corresponding line
on the pull-down entry field. The factory default is disabled.
config switchconfig broadcast
This command enables or disables broadcast storm recovery mode. If the mode is enabled,
broadcast storm recovery with high and low thresholds is implemented.