Filter
Top Products
7000 Series L3 Managed Switch Reference Manual for Software v2.0
8-10 Routing Commands
Subnet Mask Is a mask of the network and host portion of the IP address for the
OSPF interface. This value was configured into the unit. This is a
configured value.
OSPF Admin Mode States whether OSPF is enabled or disabled on a router interface.
This is a configured value.
OSPF Area ID Represents the OSPF Area Id for the specified interface. This is a
configured value.
Router Priority A number representing the OSPF Priority for the specified inter-
face. This is a configured value.
Retransmit Interval A number representing the OSPF Retransmit Interval for the
specified interface. This is a configured value.
Hello Interval A number representing the OSPF Hello Interval for the specified
interface. This is a configured value.
Dead Interval A number representing the OSPF Dead Interval for the specified
interface. This is a configured value.
LSA Ack Interval A number representing the OSPF LSA Acknowledgement Inter-
val for the specified interface.
Iftransit Delay Interval A number representing the OSPF Transit Delay for the specified
interface. This is a configured value.
Authentication Type The OSPF Authentication Type for the specified interface are:
none and simple. This is a configured value.
The information below will only be displayed if OSPF is enabled.
OSPF Interface Type Broadcast LANs, such as Ethernet and IEEE 802.5, take the value
'broadcast'. The OSPF Interface Type will be 'broadcast'.
State The OSPF Interface States are: down, loopback, waiting, point-
to-point, designated router, and backup designated router. This is
the state of the OSPF interface.
Designated Router Is the IP address representing the designated router.
Backup Designated Router Is the IP address representing the backup designated router.
Number of Link Events The number of link events.
Metric Cost Is the cost of the ospf interface. This is a configured value.
show router ospf interface stats
This command displays the statistics for a specific interface. The information below will only be
displayed if OSPF is enabled.