Filter
Top Products
7000 Series L3 Managed Switch Reference Manual for Software v2.0
7-22 Switching Commands
config trapflags multiusers
This command enables or disables Multiple User traps. When the traps are enabled, a Multiple
User Trap is sent when a user logs in to the terminal interface (EIA 232 or telnet) and there is an
existing terminal interface session.
Default enable
Format
config trapflags multiusers <enable|dis-
able>
config trapflags stpmode
This command enables or disables the sending of new root traps and topology change notification
traps.
Default enable
Format config trapflags stpmode <enable|disable>
show telnet
This command displays telnet settings.
Format show telnet
Telnet Login Timeout (minutes) This object indicates the number of minutes a telnet session is
allowed to remain inactive before being logged off.A zero means
there will be no timeout. May be specified as a number from 0 to
160. The factory default is 5.
Maximum Number of Telnet Sessions Selectable from a pull-down menus for values of from 0
to 5. This object indicates the number of simultaneous telnet ses-
sions allowed. The factory default is 5.
Allow New Telnet Sessions Indicates that new telnet sessions will not be allowed when set to
no. The factory default value is yes.
config telnet maxsessions
This command specifies the maximum number of telnet sessions that can be established. A value
of 0 indicates that no telnet session can be established. The range is 0 to 5.
Default 5
Format config telnet maxsessions <0-5>