Filter
Top Products
7000 Series L3 Managed Switch Reference Manual for Software v2.0
Switching Commands 7-21
Multiple Users Flag May be enabled or disabled by selecting the corresponding line
on the pull-down entry field. The factory default is enabled. Indi-
cates whether a trap will be sent when the same user ID is logged
into the switch more than once at the same time (either via telnet
or serial port).
Spanning Tree Flag May be enabled or disabled by selecting the corresponding line
on the pull-down entry field. The factory default is enabled. Indi-
cates whether spanning tree traps will be sent.
Broadcast Storm Flag May be enabled or disabled by selecting the corresponding line
on the pull-down entry field. The factory default is enabled. Indi-
cates whether broadcast storm traps will be sent.
config trapflags authentication
This command enables or disables the Authentication Flag.
Default enable
Format
config trapflags authentication
<enable|disable>
config trapflags bcaststorm
This command enables or disables the broadcast storm trap. When enabled, broadcast storm traps
are sent only if the broadcast storm recovery mode setting associated with the port is enabled (see
“config switchconfig broadcast” on page 24).
Default enable
Format config trapflags bcaststorm <enable|dis-
able>
config trapflags linkmode
This command enables or disables Link Up/Down traps for the entire switch. When enabled, link
traps are sent only if the Link Trap flag setting associated with the port is enabled (see “config port
linktrap” on page 27).
Default enable
Format
config trapflags linkmode <enable|disable>