Filter
Top Products
7000 Series L3 Managed Switch Reference Manual for Software v2.0
Quick Startup 6-1
Chapter 6
Quick Startup
The CLI Quick Start up details procedures to quickly become acquainted with the 7000 Series L3
Managed Switch Software.
Quick Starting the Switch
1. Read the device Installation Guide for the connectivity procedure. In-band connectivity allows
access to the 7000 Series L3 Managed Switch Software locally or from a remote workstation.
The device must be configured with IP information (IP address, subnet mask, and default
gateway).
2. Turn the Power ON.
3. Allow the device to load the software until the login prompt appears. The device initial state is
called the default mode.
4. When the prompt asks for operator login, execute the following steps:
• Type the word admin in the login area. Since a number of the Quick Setup commands
require administrator account rights, log in using an administrator account.
• Do not enter a password because there is no password in the default mode.
• Press the enter key two times.
Software Version Information
Table 6-1. Quick Start Up Software Version Information
Command Details
show inventory Allows the user to see the software version the device contains
Machine Model (The type and number of ports the device provides.)
For example:
System Description ................................ netgear
Machine Type ......………......................... 2402
Burned In MAC Address ........................ 00:06:29:32:81:40
Software Version ..................................... 2.0.0.0