Filter
Top Products
7000 Series L3 Managed Switch Reference Manual for Software v2.0
CLI Commands: Differentiated Services 9-17
Format config diffserv policy bandwidth percent <policyname>
<classname> <1-100>
Restrictions
The sum of the committed information rate values for all band-
width and expedite commands defined within a policy must not
exceed the available link bandwidth of the interface to which that
policy is assigned. Violation of this requirement shall prevent
successful attachment of a policy to the interface, or shall cause
this command to fail if the policy is already in service on one or
more interfaces.
Policy Type Out
Incompatibilities Expedite (all forms)
config diffserv policy expedite kbps
This command identifies the maximum guaranteed amount of bandwidth to be reserved for the
specified class instance within the named policy using an absolute rate notation. The
<policyname> and <classname> are the names of an existing DiffServ policy and class,
respectively. The committed information rate is specified in kilobits-per-second (Kbps) and is an
integer from 1 to 4294967295. The optional committed burst size is specified in kilobytes (KB) as
an integer from 1 to 128, with a default of 4.
Note: The actual bandwidth allocation does not occur until the policy is attached to an interface in
a particular direction.
Note: The expedite kbps and percent commands are alternative ways to specify the same expedite
policy attribute.
Format config diffserv policy expedite kbps <policyname>
<classname> <1-4294967295> [1-128]
Restrictions
The sum of the committed information rate values for all band-
width and expedite commands defined within a policy must not
exceed the available link bandwidth of the interface to which that
policy is assigned. Violation of this requirement shall prevent
successful attachment of a policy to the interface, or shall cause
this command to fail if the policy is already in service on one or
more interfaces.
Policy Type Out
Incompatibilities Bandwidth (all forms), Shape Peak