Filter
Top Products
Pacific Research Solutions RI-300e User Manual
Page 92
S-Cmd 76 TELEPHONE TX RING LIMIT
This command limit of the total number of ring messages to be transmitted. Do not use the no-limit mode of this command with
S-Command 71, modes 2 through 4; the repeater will not stop ringing over the air.
SYNTAX: 76 [Ring]
READ BACK 76
STORAGE: RAM/EEPROM
PARAMETERS: Ring 0 = No limit, 1-31 = Maximum number of rings over the air.
DEFAULT: 8 Rings
EXAMPLE: 76 15 Set maximum rings on the repeater to 15.
S-Cmd 77 TELEPHONE OFF-HOOK TIME-OUT TIMER
This command will limit the maximum duration of a telephone call. This timer will start when the telephone goes off-hook.
Upon expiration of the time-out, a warning message will be started. 30 seconds later, the telephone will hang up. During the
30-second warning message, you can reset this timer by re-sending the off-hook user command.
SYNTAX: 77 [Time]
READ BACK 77
STORAGE: RAM/EEPROM
PARAMETERS: Time 0 = Not time-out, 1-240 = Minutes
DEFAULT: 10 Minutes
EXAMPLE: 77 30 Set off-hook time-out for 30 minutes
S-Cmd 78 TELEPHONE INACTIVITY ON RECEIVER TIME-OUT TIMER
When a telephone call is established, the controller will check the repeater receiver activity. Each time the receiver state
changes (COS on or off) the inactivity timer is reset. If there is no receiver change of state before the time-out occurs, the
telephone will go on-hook. This timer is useful if someone travels out of range of the repeater, or if another transmitter locks up
the repeater input.
SYNTAX: 78 [Time]
READ BACK 78
STORAGE: RAM/EEPROM
PARAMETERS: Time 0 = Not time-out, 1-240 = Seconds
DEFAULT: 60 Seconds
EXAMPLE: 78 120 Set inactivity on receiver time-out for 120 seconds.