Filter
Top Products
Pacific Research Solutions RI-300e User Manual
Page 70
S-Cmd 34 AUXILIARY OUTPUT MODE
The auxiliary port allows you to connect multiple RI-300 controllers together or connect the RI-300 to someone else’s existing
controller. This command sets up the mode for the output of audio and PTT logic to other controllers. The RI-300 has 8 audio
channels connected to the auxiliary buss. Use S-Command 39 to assign a channel on which to output both audio and serial
data. This command is then used to enable audio output on that channel. See section 16 “Setting Up Audio Channels” for more
information on this subject.
SYNTAX: 34 [Mode]
READ BACK: 34
STORAGE: RAM/EEPROM
PARAMETERS: Mode 0 =
Off:
Used to disable the auxiliary output. The controller will not send audio or control logic
out the auxiliary buss for other controllers to receive.
Mode 1 =
COS:
The controller will send audio out the auxiliary buss when the local controller’s receiver
is active; CTCSS/DCS is ignored.
Mode 2 =
Initial access with CTCSS/DCS and COS then access is changed to only COS:
This
function is reset when the transmitter drops. Use in applications where a user may have a weak
signal and the tone decoder is falling out of range.
Mode 3 =
COS and CTCSS/DCS:
The controller will send audio out the auxiliary buss when the local
controller’s receiver and auxiliary tone panel is decoding.
Mode 4 =
Open Squelch: