Filter
Top Products
Pacific Research Solutions RI-300e User Manual
Page 34
Review the following procedure to
understand how this “Hello” ID
was entered into the controller.
When you un-key your radio after
each command, you should hear
the character number in speech.
This will tell you that you did
everything correctly. If you hear
an “ERROR”, a mistake was made
and the command was aborted.
You can also use the programming
software to edit this message. Pick
“Triggers” then pick “Messages”,
highlight “Station ID” item 11 then
pick “Edit Msg.”. You will see the
message edit box as displayed on
the right. Use the same message
editing format to enter your
message commands as shown
below.
S-Command
Description
1. 123456 If you are using DTMF, unlock the controller, you are in S-Command mode.
You should notice a different courtesy tone.
2. 63 038 If you are using DMF, S-Command 63 sets the memory data pointer (start line number pointer)
to start line 038. If you are using the programming software, you can use the macro editor to
select the start line.
3. 31 001 S-Command 31, Enter message data into memory, Start Of Message.
4. 31 036 S-Command 31, Enter message data into memory, Set Tone Generator 1 to 400 Hz tone.
5. 31 079 S-Command 31, Enter message data into memory, Set Tone Generator 1 to output level 15
6. 31 118 S-Command 31, Enter message data into memory, Turn Tone Generator 2 off
7. 31 212 S-Command 31, Enter message data into memory, CW Speed, 16 WPM
8. 31 239 S-Command 31, Enter message data into memory, CW “H”.
9. 31 236 S-Command 31, Enter message data into memory, CW “E”.
10. 31 243 S-Command 31, Enter message data into memory, CW “L.
11. 31 243 S-Command 31, Enter message data into memory, CW “L.
12. 31 246 S-Command 31, Enter message data into memory, CW “O”.
13. 31 002 S-Command 31, Enter message data into memory, End Of Message.
14. 64 S-Command 64, Terminate the end of this memory segment.
15. If you are using the programming software, pick the “OK” button then pick the “Send” button
to update the controller.
16. 68 038 If you are using DTMF, S-Command 68 will trigger the message or macro at start line 038.
Use this to test your message. If you are using the programming software, you can use the
“Send S-Cmd” dialog box to test this macro.
17. 69 1 If you using DTMF, S-Command 69 1 will lock the controller and save data, you are done.
Now you are ready to enter YOUR ID message. Use the above example to organize your message. It is important to know how
the memory is organized so that you will know what the next available start line will be. The table below shows the default ID
and how the above data was stored into memory.