Filter
Top Products
Pacific Research Solutions RI-300e User Manual
Page 96
S-Cmd 87 EDIT TELEPHONE NUMBER ACCEPT TABLE
The telephone number accept table is used to control which telephone numbers are allowed for dialing. If the reject table is
turned off, only numbers in the accept table will be allowed for dialing. If the reject table is turned on and the controller does
not find a match in the accept table, the controller will look for a match in the reject table. If the controller finds a match in the
accept table, the controller will only look in the reject table positions 50 through 99 for a reject match. We call this an
exception and can be used to reject specific numbers in a group of accepted numbers. You could reject all toll calls and accept
one or two toll call area codes but reject a group of numbers within those area codes, like 976 numbers. Valid digits are 0
through 9, *, # and A for one second pause. “*” Is used as wild card digit, and a “*” at the end of the string acts as a wild card
for multiple digits. You should include a “*” at the end of all entries to limit extra digits from being used. See section 15,
telephone interconnect, for additional information on the use of the accept and reject tables.
SYNTAX: 87 [Accept position] [Telephone number]
READ BACK 87 * [Accept position]
STORAGE: EEPROM
PARAMETERS: Accept position = 00 to 99
Telephone number = 0 to 16 digits, 0 digits will clear the accept number
DEFAULT: Nothing stored.
EXAMPLE: 87 00 15306729053* Accept Pacific Research Solutions number for dialing, position 00
87 01 1213* Accept all numbers in the 213 area code for dialing, position 01
S-Cmd 88 TELEPHONE NUMBER REJECT TABLE ENABLE
This command will either enable or disable the reject number table. If the accept table is off, and the reject table is on, only
numbers that do not match the reject table will be available for dialing. See section 15, telephone interconnect, for additional
information on the use of the accept and reject tables.
SYNTAX: 88 [on/off]
READ BACK 88
STORAGE: RAM/EEPROM
PARAMETERS: 0 = Off and 1 = On
DEFAULT: 0
EXAMPLE: 88 1 Turn on the reject table.